Setup Vizio E series channel

Setup Vizio E series channel

 Setup Vizio E Series channel autoscan

Hello there, just purchased the E Series already? Okay, it's sound pretty good news to you. For you that find a way how to setup Vizio E Series channels, don”t to worry as we have several guidance to you perform Vizio E Series TV autoscan.
Before we explain how to setup channels on Vizio E Series TV, we inform you that partially or whole steps to perform the method can be vary depending on your TV model. So for full explanation how to scan it will be better always to see the manual book for each TV model.
Well, let get started by turn on your TV followed by these steps:
  1. Make sure that antenna’s cable is plugged on TV  Setup Vizio E Series channel autoscan 
  2. On your remote, press the “INPUT” button to display option of some input sources. To do the auto scanning, select the TV (coaxial cable). Note that some models may display “TV”, “ANT”, etc.Setup Vizio E Series channel autoscan 
  3. Now, simply press the menu button on your remote, then navigate down to “Settings” option and press “OK” button.
    Setup Vizio E Series channel autoscan
  4. At “Input Source” option, make sure it is set to TV so that you can see the “Tuner” Option. (the display could be different on some models)
    Setup Vizio E Series channel autoscan

  5. Click the “Tuner” to open the “Tuner Settings” option
    Setup Vizio E Series channel autoscan
  6. After that, at “Tuner Mode” line set the option to Antenna if you use the over the air broadcasting, while the “Cable” option is for cable out of the wall for tuner.
  7. Once you choose that, now navigate the highlight to “Auto Channel Scan” and OK. (the display could different on some models)
  8. The channel scan will begin searching for any broadcast nearby, wait until the process is done. Usually the scanning can take a few minutes.
    Setup Vizio E Series channel autoscan
  9. When the process reaches 100% and it is complete, now exit the menu.
  10. A sort of available channels should appear.
  11. You can press the Channel Up or Channel Down button to turn between available channels.
Sometimes you find any problem and feel not satisfied for the acquired channels and eager to run channel autoscan again we suggest to clear the TV memory as the following steps:
  1. Shut down the TV first.
  2. Remove your TV power cable from the electrical source.
  3. This is the important step, press and hold the Power button for about 30 seconds on your TV.
  4. Release the power button after long press.
  5. Plug the power cable of your TV back into the electrical source.
  6. Turn the TV on
  7. Run the channel scan again.
If the problem persists, you may doing these steps:
  1. Unplug the coaxial cable from the connector behind your TV
  2. Perform the autoscan on your E Series TV like the steps above (the process should result no channels acquired)
  3. Make sure your TV has no channels.
  4. Plug the coaxial cable into the TV
  5. Run the autoscan again.
Additional information that you can also clear memory on Vizio E Series TV by resetting it to the Factory settings. The reset option is in the “Setup” or “System” option inside the Menu. The option may varies as it is listed as “System Reset”, “Reset & Admin” or “Reset all settings”, please see the manual for further information.

Related Posts: